DLS CC-500 Spezifikationen

How to install and operate the DLS amplifier modelsWelcome!This owners manual is written in easy english anduses a lot of drawings to simply the insta

10If problems occour during the installation, or later, this guide might help you to find out whats´s wrong.THE AMPLIFIER IS DEAD:1. Check power lead,

NOISE PROBLEMSWHINING NOISE VARYING WITH ENGINE REVOLUTIONS: Do this:1. Rewire the power supply (12 V) to source unit direct from battery. 2.

SpecificationsWe follow a policy of continuous advancement in development. For this reason all or part of specifications & designs may be changed

The models include the following features:- Analogue class AB or D technique- High efficiency- Low profile design- RCA line inputs - High level input

3Tools and material neededTools:  Flat and Phillips screwdrivers Wire cutter Wire stripper

Connect left and right speaker wires coming from the car stereo to the high level input as shown. You must connect both plus and minus as the inputs a

Input Level control - GAIN The GAIN control, MIN – MAX, matches the output of your radio to the input of the amplifier. After installation is compl

CC-500Speaker wiring CC-500Two 4 ohm subwoofersOne 4 ohm or 2 ohm subwoofer6NOTE!Two 4 ohm subwoofers gives a 2 ohm load when connected in this way.Mi

CC-2Speaker wiring CC-2Two fullrange speakers to channel 1 / 2One 4 ohm subwoofer bridged7For power wiring, see page 3-4For high or low level input wi

82. Two fullrange speakers and one subwoofer bridged to CC-4 (3-channel mode). Filter settings front channels CH 1 / 2Speaker wiring CC-41. Four

93. Two subwoofers or stereo speakers brid-ged to CC-4.Filter settings front channels CH 1 / 2Speaker wiring CC-4Filter settings rear channels CH 3 /